Sophomore
Currently Offline
Posts: 91
A+'s: 0
Joined: Nov 1, 2012 15:45:10 GMT -6
|
Post by 04prixgt04 on Jan 14, 2013 18:39:26 GMT -6
I would think that if I get it tuned right I would not need to worry about the battery. It would start with a kick start. But until then I don't know lol I'll have to wait
|
|
Sophomore
Currently Offline
Posts: 91
A+'s: 0
Joined: Nov 1, 2012 15:45:10 GMT -6
|
Post by 04prixgt04 on Jan 14, 2013 18:26:03 GMT -6
hahaha. drinking a cold 1 now lol from outside who needs a refrigerator when it's freezing. Anyways ex girlfriend said no she cannot come jump me in the morning. So I'm hoping I'm going to go to Walmart and get a battery charger in a minute if I can afford it I have about 30 bucks to my name. the kickstarts not doing it. Plus it's getting a little late and I don't wanna piss neighbors of too much. it's looking like I have about an hour tonight and maybe 2 hours in the morning if I wake up at 8am. To get this bad boy going
|
|
Sophomore
Currently Offline
Posts: 91
A+'s: 0
Joined: Nov 1, 2012 15:45:10 GMT -6
|
Post by 04prixgt04 on Jan 14, 2013 18:12:48 GMT -6
well it started right up with the battery but now the battery is dead again and only have enough juice from 1 start. And kick starting is not giving me any luck at all but it did start up an idle for about 10 seconds before I turned it off sure wish I would've let it go longer to charge the battery. But I wasn't thinking. Anyways I don't know what to do at this point I'm screwed lol I'm going to hope to my ex girlfriend will come over and give me a jump start in the morning in letting it run will charge the battery. We will see any tips on fine tuning?
|
|
Sophomore
Currently Offline
Posts: 91
A+'s: 0
Joined: Nov 1, 2012 15:45:10 GMT -6
|
Post by 04prixgt04 on Jan 14, 2013 18:08:54 GMT -6
it started right up. Well actually to get a couple tries but it started and it started by battery too. It took 3 turns to shut it 1 and a half open and it started idling kinda high though. I think it's becauseit's on the center stand in the wheels off the ground but I'm not sure how should I adjust it? And thank you thank you thank you thank you thank you thank you I really didn't want to pay a lot of money and walk in the freezing cold to ride the stupid bus. I much rather drive in the freezing freezing freezing cold lol
|
|
Sophomore
Currently Offline
Posts: 91
A+'s: 0
Joined: Nov 1, 2012 15:45:10 GMT -6
|
Post by 04prixgt04 on Jan 14, 2013 17:57:53 GMT -6
I'mputtingonjacketsanddoingitnow.
|
|
Sophomore
Currently Offline
Posts: 91
A+'s: 0
Joined: Nov 1, 2012 15:45:10 GMT -6
|
Post by 04prixgt04 on Jan 14, 2013 17:04:11 GMT -6
okay. the batts dead now. wil kick start be rnogh to tell? before I bundle up lol
|
|
Sophomore
Currently Offline
Posts: 91
A+'s: 0
Joined: Nov 1, 2012 15:45:10 GMT -6
|
Post by 04prixgt04 on Jan 14, 2013 16:28:22 GMT -6
yes the spark plug is gap correct. And 1 spark plug is a denso u22fs meant for a gy6 150 cc the other is a knock off brand came with the scooter. Both still spark the 1 that came with the scooter is the 1 that is not black. It is still a really good plug in my opinion. And as far as the black stuff I'm pretty sure it is sooty. it does not wipe off. So what do I do next?
|
|
Sophomore
Currently Offline
Posts: 91
A+'s: 0
Joined: Nov 1, 2012 15:45:10 GMT -6
|
Post by 04prixgt04 on Jan 14, 2013 13:12:13 GMT -6
I think about it the more I'm pretty sure to ignition related. There's no reason for that spark plug to look bad bad after only 401.1 miles
|
|
Sophomore
Currently Offline
Posts: 91
A+'s: 0
Joined: Nov 1, 2012 15:45:10 GMT -6
|
Post by 04prixgt04 on Jan 14, 2013 12:54:35 GMT -6
well my issue with that is it's been running perfect for a while so I don't think it's a problem with spark plug plus it has not done it again I'm trying to 3 * so far 1 time I actually gapped it a lot more than it was supposed to be to see if it would change it and it did not. I think when I put the plug in it was already screwed up and I just did not notice. The scooter still does not start over I squirted starter fluid Street in the spark plug hole in acted like you wanted to start for just a second but it did not. There's definitely gas in the filter I can see a difference in the amount so I know it's getting gas to it. I don't know what you think my spark is really strong I can see it bright even in the daylight. a covered up the intake to the car to see if it was a choke problem and no difference at all. the bank only have 700 miles so I really don't think it's a problem with the compression. Also I can hear the compression so I know I think I'm good as far as that goes so that covers Sport fuel compression air, what else is there?
|
|
Sophomore
Currently Offline
Posts: 91
A+'s: 0
Joined: Nov 1, 2012 15:45:10 GMT -6
|
Post by 04prixgt04 on Jan 14, 2013 11:50:03 GMT -6
I regapped the plugand put it back into re send me later problem twice and it did not happen. Maybe I matched it down when I was putting the plugin in the first plug was already screwed up and I did not notice. I also sprayed the starter fluid straight into the board through the spark plug hole in it acted like you wanted to start for second I wasn't able to get much in there I'm going to try to find a strong try again and see what happens I'll fill you in
|
|
Sophomore
Currently Offline
Posts: 91
A+'s: 0
Joined: Nov 1, 2012 15:45:10 GMT -6
|
Post by 04prixgt04 on Jan 14, 2013 9:25:44 GMT -6
also when I put the starter fluid in I noticed it coming out in bursts every time the starter turn engine over. It was coming out of the hole in the plastic cover where the spark plug goes not sure if some got in there in the fan was blowing it out out if there isactually a hole in the enginelol. it is way too cold outside I'm going to wait for a reply before I take anything apart. edit: the plug on the left is only a few weeks old. . The 1 on the right is the 1 the bike came with only had 300 miles on it. the only thing I can think of is that I got about 82 inch piece of electrical tape in the engine bore through the spark plug hole 1 first first got the scooter  |
|
Sophomore
Currently Offline
Posts: 91
A+'s: 0
Joined: Nov 1, 2012 15:45:10 GMT -6
|
Post by 04prixgt04 on Jan 14, 2013 9:23:27 GMT -6
okay. At this point I I did take an extra plugs stick it in the boot in got sport. Change this cylinoid with a brand new 1 anyways still got spark. so I went ahead and put starter fluid in the car nothing. Take out the spark plug in noticed it was smashed the element was at the tip anyways. So I was like damn you looked at it it's also burnt really bad on the ceramic. So I put a new plug in nothing to can you plug out it's also smashed. Any ideas?
|
|
Sophomore
Currently Offline
Posts: 91
A+'s: 0
Joined: Nov 1, 2012 15:45:10 GMT -6
|
Post by 04prixgt04 on Jan 14, 2013 4:39:51 GMT -6
yes. has a clamp on the end like it was connected to something also looks melted at the end. The end that hangs that is
|
|
Sophomore
Currently Offline
Posts: 91
A+'s: 0
Joined: Nov 1, 2012 15:45:10 GMT -6
|
Post by 04prixgt04 on Jan 13, 2013 13:03:38 GMT -6
it comes right off of the valve cover in just dangles but it has a clip like it was plugged into something
|
|
Sophomore
Currently Offline
Posts: 91
A+'s: 0
Joined: Nov 1, 2012 15:45:10 GMT -6
|
Post by 04prixgt04 on Jan 12, 2013 23:56:30 GMT -6
well.got keys. no go .... I tried 3 different uses. And nothing it's like it won't do anything at all it kicks over and goes nah nah nah nah nah nah.I am going to borrow a truck tomorrow to pick it up. And bring it home I guess I'm going to start with the ignition coil I have that brand new set aside . I'm going to search will not start lol on this forum and see what I can find and ask questions later.
|
|
