Sophomore
Currently Offline
Ultimate LAD
Posts: 92 
A+'s: 1
Joined: Oct 10, 2013 15:36:57 GMT -6
|
Post by churchy on Oct 13, 2013 10:04:16 GMT -6
no  |
|
Sophomore
Currently Offline
Ultimate LAD
Posts: 92
A+'s: 1
Joined: Oct 10, 2013 15:36:57 GMT -6
|
Post by churchy on Oct 12, 2013 7:08:30 GMT -6
not fuse
dont tink brake light switch as they work when running
not dead battery
how do i check key switch, grounding, or a wiring fault?
|
|
Sophomore
Currently Offline
Ultimate LAD
Posts: 92
A+'s: 1
Joined: Oct 10, 2013 15:36:57 GMT -6
|
Post by churchy on Oct 12, 2013 7:05:41 GMT -6
i did say it was an 03 reg next to make and model  |
|
Sophomore
Currently Offline
Ultimate LAD
Posts: 92
A+'s: 1
Joined: Oct 10, 2013 15:36:57 GMT -6
|
Post by churchy on Oct 12, 2013 3:56:15 GMT -6
yes it comes with cyllinder head cyllinder piston piston rings circlips and gudeon pin
|
|
Sophomore
Currently Offline
Ultimate LAD
Posts: 92
A+'s: 1
Joined: Oct 10, 2013 15:36:57 GMT -6
|
Post by churchy on Oct 11, 2013 19:32:29 GMT -6
ordered new cylinder, is there anything i have to do before during after fitting?
|
|
Sophomore
Currently Offline
Ultimate LAD
Posts: 92
A+'s: 1
Joined: Oct 10, 2013 15:36:57 GMT -6
|
Post by churchy on Oct 11, 2013 14:25:20 GMT -6
|
|
Sophomore
Currently Offline
Ultimate LAD
Posts: 92
A+'s: 1
Joined: Oct 10, 2013 15:36:57 GMT -6
|
Post by churchy on Oct 11, 2013 10:24:01 GMT -6
i like the warm welcome, its all pretty much the same over here, just no trikes, always wet (sliding peds!!!) and always getting pulled over by the police for no good reason!
|
|
Sophomore
Currently Offline
Ultimate LAD
Posts: 92
A+'s: 1
Joined: Oct 10, 2013 15:36:57 GMT -6
|
Post by churchy on Oct 11, 2013 10:09:21 GMT -6
Ok so first thread, first problem, when i turn the key in the ignition to on i get no power to anywhere, lights, horn, dash, nothing. Therefore my electric start wont work! However one the engine is running (via the kicker) everything works including starter motor! I just dont know what to do about this or where to start, electrics are really not my thing!
any help would be much appreciated.
Cheers
Yamaha Jog r/MBK Mach G 03
Stage 6 Street Race 70cc
Stage 6 Pro Variator
Stage 6 Pro Rep Pipe
Home Made Truck Horn
|
|
Sophomore
Currently Offline
Ultimate LAD
Posts: 92
A+'s: 1
Joined: Oct 10, 2013 15:36:57 GMT -6
|
Post by churchy on Oct 11, 2013 4:08:24 GMT -6
please dont forget about that, i have broken two ribs a find it impossible to kick hence why i ned the electrics
|
|
Sophomore
Currently Offline
Ultimate LAD
Posts: 92
A+'s: 1
Joined: Oct 10, 2013 15:36:57 GMT -6
|
Post by churchy on Oct 10, 2013 17:00:47 GMT -6
Ok so i was on route to college, when i was stopped at a junction, when i came to pull away i noticed that all of a sudden the revs had to get very high for the ped to move even then with poor acceleration, normally it has high bottom end power and is quick off the mark, up to about 10 mph it did this then went back to normal but it kept doing this, then i pulled over to read a text leaving engine at idle and it cut out, now it just dosent work!!
there is a spark, new plug, cleaned carb with carb cleaner, fuel getting to carb and to inlet, took off cyllinder head to see if fuel got into the cylinder, it did. but the head of the piston had a few small chips in it at the edges, then i removed the piton to see that the first piston ring was in bits and the second bent, this had marked the cylinder sleve, only lightly and in one place. would this damage to the piston be enough for it not to start?
|
|
Sophomore
Currently Offline
Ultimate LAD
Posts: 92
A+'s: 1
Joined: Oct 10, 2013 15:36:57 GMT -6
|
Post by churchy on Oct 10, 2013 16:54:37 GMT -6
ok so the day i recieved the ped electric start worked...then after the first use nothing.. thought it blew fuse but didnt know where fuse was so didnt look, too it back to garage he put a 15 amp fuse in it worked electric start once then nothing i moved back to 7.5 still nothing, i have a multimeter, can you describe to me the wires i should be testing off the top of your head and the process i would go about using?
|
|
Sophomore
Currently Offline
Ultimate LAD
Posts: 92
A+'s: 1
Joined: Oct 10, 2013 15:36:57 GMT -6
|
Post by churchy on Oct 10, 2013 16:27:56 GMT -6
it is a blad fuse and using 7.5 A its what it says to use in manual, changed it, still nothing.
|
|
Sophomore
Currently Offline
Ultimate LAD
Posts: 92
A+'s: 1
Joined: Oct 10, 2013 15:36:57 GMT -6
|
Post by churchy on Oct 10, 2013 16:00:45 GMT -6
17
Yammah Jog r/MBK Mach G 03
Stage 6:
Streetrace 70 kit
Pro Variatior
Pro Rep Pipe
England
Sussex
Burgess Hill
Young
Dumb
Full of GUM(you change this again and your out of here) we do not allow profane language and either does PROBOARDS the owners of the forums.
Alleyoop
(i thought i was being retarded and kept on misspelling it lol, was gum the best you could think of lol)
|
|
Sophomore
Currently Offline
Ultimate LAD
Posts: 92
A+'s: 1
Joined: Oct 10, 2013 15:36:57 GMT -6
|
Post by churchy on Oct 10, 2013 15:51:54 GMT -6
Ok so first thread, first problem, when i turn the key in the ignition to on i get no power to anywhere, lights, horn, dash, nothing. Therefore my electric start wont work! However one the engine is running (via the kicker) everything works including starter motor! I just dont know what to do about this or where to start, electrics are really not my thing!
any help would be much appreciated.
Cheers
Yamaha Jog r/MBK Mach G 03
Stage 6 Street Race 70cc
Stage 6 Pro Variator
Stage 6 Pro Rep Pipe
Home Made Truck Horn
|
|
