|
|
Post by cruiser on Apr 15, 2012 21:29:12 GMT -6
Welcome to the forum, Terry. Sure is a nice lookin' scoot. Did you install a BBK? Some of these scoots came from the factory with 44mm pistons which would make the engine about 60cc. I believe mine has the 60cc factory engine.  My first scoot. |
|
|
|
Post by cruiser on Apr 14, 2012 23:46:54 GMT -6
Justbuggin2 may be on the right track. Did you adjust the valves yet? If not, it might also be a good opportunity to see how all the timing marks line up. Maybe it could be valve gaps or a timing problem or both?
|
|
|
|
Post by cruiser on Apr 14, 2012 19:13:12 GMT -6
|
|
|
|
LED Lights
by: cruiser - Apr 14, 2012 16:52:21 GMT -6
Post by cruiser on Apr 14, 2012 16:52:21 GMT -6
Perfect. Thanks for the reply cruiser Your welcome. |
|
|
|
Post by cruiser on Apr 13, 2012 21:14:25 GMT -6
Like terrilee said, you don't know what's in there.
I would change all liquids immediately. Some people even change the brake fluid.
The hard break in where you run the engine through normal operating speeds is what I used. Just don't hold any speed too long for the first one or two hundred miles.
Using the recommended viscosity dino (not synthetic) is a good idea for the engine break in oil. I would change it out after one or two hundred miles and then do another change at about five hundred miles and then change to synthetic for regular oil change intervals.
I would change out the gear oil after about one thousand miles and then once a year after that. I use synthetic gear oil in the recommended viscosity.
Some people have had good results using 0W-40 oil in the engine as it gives better cold starting protection and also flows better to help cool the engine after it's warmed up.
|
|
|
|
LED Lights
by: cruiser - Apr 13, 2012 20:54:55 GMT -6
Post by cruiser on Apr 13, 2012 20:54:55 GMT -6
|
|
|
|
Post by cruiser on Apr 13, 2012 14:19:03 GMT -6
damin69 says to get a 30 amp relay from auto zone will this work ? Yes. |
|
|
|
Post by cruiser on Apr 12, 2012 20:56:11 GMT -6
wont the lights come on when i turn on the key with the relay instead of diode? Yes. |
|
|
|
Post by cruiser on Apr 12, 2012 20:48:42 GMT -6
|
|
|
|
Post by cruiser on Apr 11, 2012 21:37:18 GMT -6
|
|
|
|
Post by cruiser on Apr 11, 2012 19:57:49 GMT -6
|
|
|
|
Post by cruiser on Apr 11, 2012 19:55:16 GMT -6
Welcome to the forum fellow YY250T owner. Post some pics when you have a chance. Don't forget the PDI since this will avoid possible problems down the road.
|
|
|
|
Post by cruiser on Apr 9, 2012 20:07:42 GMT -6
|
|
|
|
fly wheel
by: cruiser - Apr 8, 2012 21:50:49 GMT -6
Post by cruiser on Apr 8, 2012 21:50:49 GMT -6
|
|
|
|
Post by cruiser on Apr 8, 2012 20:37:13 GMT -6
|
|
