|
|
Post by justbuggin2 on May 4, 2013 8:22:58 GMT -6
Alley you seem to have an indefinite amount off ref martial at hand
|
|
|
|
Post by justbuggin2 on May 3, 2013 23:30:07 GMT -6
the connector is def than a CDI box would have so something to do with the lights or security sys would be my best guess
|
|
|
|
Post by justbuggin2 on May 3, 2013 19:52:33 GMT -6
do you have snow chains for thoe scoots ?
|
|
|
|
Post by justbuggin2 on May 3, 2013 19:33:29 GMT -6
DX
|
|
|
|
Post by justbuggin2 on May 3, 2013 8:20:23 GMT -6
if you cut it loose at both ends it will be just a dead wire in the harness
|
|
|
|
Post by justbuggin2 on May 2, 2013 21:37:14 GMT -6
i would get some good wire and replace the yellow wire it self from what your test readings are there is a break in the yellow wire
|
|
|
|
Post by justbuggin2 on Apr 30, 2013 22:25:43 GMT -6
i see where you are coming from i would like to have a big scooter for the highway as i would love to be able to get there in a hurry and when i am there i can always slow down and enjoy the view
|
|
|
|
Post by justbuggin2 on Apr 30, 2013 22:15:26 GMT -6
DX and i would go through all the grounds checking that they are clean and tight some times the factory over crimps the ends connectors on the battery cables causing problems i would just go ahead and replace them it took care of alot of strange electrical problems for me
|
|
|
|
Post by justbuggin2 on Apr 30, 2013 22:06:28 GMT -6
you may need to up the jet one or two sizes other than that i dont think you will have to mess with anything except for the mounting brackets for the muffler
|
|
|
|
Post by justbuggin2 on Apr 30, 2013 7:47:52 GMT -6
|
|
|
|
Post by justbuggin2 on Apr 29, 2013 22:27:12 GMT -6
polarity does have alot to do with LEDs as current only flow one way through them
|
|
|
|
Post by justbuggin2 on Apr 29, 2013 0:35:27 GMT -6
LEDs are light emitting diodes current only goes through them in one way reg bulbs current can go though both ways if the bulb will only if one way you will need to switch the wires from side to side you may need to cut and splice them to do so
|
|
|
|
Post by justbuggin2 on Apr 28, 2013 18:03:24 GMT -6
it can also be the polarity of the front sockets is reversed
|
|
|
|
Post by justbuggin2 on Apr 28, 2013 14:12:00 GMT -6
Jr is the wiring guru he be able to help i think in it tech section he has a dianiose guide
|
|
|
|
sliders
by: justbuggin2 - Apr 27, 2013 22:27:55 GMT -6
Post by justbuggin2 on Apr 27, 2013 22:27:55 GMT -6
i should know this by now but what is the correct way to install sliders i can get to the variator and all that but which way does these sliders go in?
|
|
