Rubber Floorboards By Ernie (Read 1,776 times)

[Ernie]

Has anyone gone ahead and installed rubber floorboards over the aluminum? It really improves the look and you don't have to worry about scratching the aluminum anymore.

Ernie

[JR]

I haven't yet Ernie but if I ever do get some time I'm going to do it, I just like the looks better!

JR

[Ernie]

You wouldn't think such a minor change would matter but it turns it into a better looking scooter.

[richardthescooter3]

Ernie, I'd like to try it in the near future

[hulk24]

how about a picture of it ?

[Ernie]

Scroll down to bottom of page to New Rubber Floorboards for a pic.
Ernie

[scooterelements]

Man i tell you i love the rubber floormats better than the aluminum. overtime the aluminum ones get scratched and start looking ugly.

[speedracer]

Ernie, what holds them in place and where did you get them?

[hulk24]

can someone post the picture ? i cant find it anywhere

[speedracer]

Hulk24 I like the look of the scooter you are getting. I thought Icebear just sold trikes. I like that built in back rest. Is it really a 300cc scooter?

[hulk24]

Thanks Speedracer...I love the look of it compare to my 150 cc Roketa 2008 scooter. Yes its really a 300cc..

[alleyoop]

Yes that is a nice looking scoot, they are punched out 250s they are actually 279 ccs 19hp
They should cruise in the 60s all day long. They also have another one called 300D.
Alleyoop
.icebearatv.com/pst300-11" rel="nofollow" target="_blank">.icebearatv.com/pst300-11,cosmo.htm

[hulk24]

hey Alleyoop, where i bought that scooter. They have it rated going 84 mph. Soon as it warms up outside and plus after the break end period for the scooter. Then I can open it wide open and see how fast it really goes. I plan on using my GPS to get a true reading.

[Ernie]

Jan 27, 2012 21:07:34 GMT -6 speedracer said:

Ernie, what holds them in place and where did you get them?

Here is the link to where I got the diamond pattern rubber for the floorboards. .rubbercal.com/Diamond_Plate.html" rel="nofollow" target="_blank">.rubbercal.com/Diamond_Plate.html
One sheet 12" X 48" is sufficient. $8.50 + shipping

I traced the rubber around the aluminum floorboard then cut it exactly the same size as the aluminum floorboard. I used Roberts 2-sided sticky carpet tape to mount the rubber to the floorboard. Then I poked holes in the rubber from underneath the aluiminum floorboard for the screws. I went up one size from the OEM screws X 1" and used decorative stainless washers. Screw the whole thing on to the scooter as you normally would. Don't make the screws too tight as the decorative washers will cut the rubber. There is a picture at the beginning of this post.

Have fun
Ernie

i121.photobucket.com/albums/o210/egn6/P1000457.jpg

[speedracer]

Yup, we got off subject as we waited for the picture of the finished project. Looks great Ernie, you did a nice job with it.