Reverse housing and gears for 150cc on viking pst150-8 By dragonsavage28 (Read 856 times)

[dragonsavage28]

I have 2009 icebear pst150-8 viking terike ( ruckus clone )...I've been wondering about the reverse system on it...is there any way that we can get new engine case block and take reverse gear and housing off the old engine and put on new engine case???would this work??? I want to get new engine case that already been bored out for big bore kit and slap on reverse system without modding my framing to make it fit????I found some engine that has reverse build-in but engine and shock bushing measurement is off and require to mod the rear framing I don't want to mod my framing..anyone out there know about this???help please...thanks

Sent from my HP 7 using proboards

[alleyoop]

Unfortunately no, the casing on the Trikes are different than for buggies they are made to fit the trikes swing arm.
Alleyoop

[dragonsavage28]

So that means I'll have to use same engine casting from my trike and bore the engine for bigbore with stroker ..

Sent from my HP 7 using proboards

[alleyoop]

That is correct:
Alleyoop

Here is what my PST150H Ice Bear Trike currently has it was a 149.6cc Motor now it is 182cc motor:
62mm BBK
60mm Stroker Crank
Reduction gear is 42 teeth
16/37 Hoca Tranny Gears – Original were 13/40 - I have 18/36 gears that I have not tried yet
K&N Air Filter with a Short Stack
SuperTrapp Muffler
1 1/4 Header Pipe- Had it made
24mm Carb
#122.5 Main Jet
#38 Pilot Jet
Peformance Coil/CDI- Cdi is one that is retarded at low rpms but advances at 3000 rpms, my motor has so much compression it kicksback with any other fixed advanced performance CDIs.
Manual Choke
Iridium Plug
Prodigy Variator
12g Dr. Pulley Sliders
205/65-10 Kenda Load Tires-3"s taller than OEM
29 tooth Drive Sprocket-came with 24 tooth.
DID 428 Pro V Series O-Ring Chain
Givia 29" tall Windshield
All Led bulbs Except the Headlights-I do not drive at night
4 way Flasher
Turn Signal Beeper
Relay for the Beeper connected to the Brakes
VIP Trunk with Led lights
Radio with SD card,MP3 connections

[chefhl]

which burb.?
I grew up around Des Plaines and last lived in Libertyville before migrating south to Fl.

[dragonsavage28]

Can I change tranny gear? Even If it has reverse housing on it?? I'd like to change my tranny gear for good torque and speed.

Sent from my HP 7 using proboards

[tvnacman]

can you post a picture of where the shift lever goes into the case ?

I might have an idea .

John

[alleyoop]

Yes you can change your tranny gears does not effect REVERSE.

Also count the number of teeth on the SPROCKET the chain is on coming out of your tranny.
Alleyoop