New Student
Currently Offline
Posts: 6 
A+'s: 0
Joined: Jan 5, 2014 11:10:09 GMT -6
|
Post by dragonsavage28 on Jan 6, 2014 13:33:06 GMT -6
Can I change tranny gear? Even If it has reverse housing on it?? I'd like to change my tranny gear for good torque and speed.
Sent from my HP 7 using proboards
|
|
New Student
Currently Offline
Posts: 6
A+'s: 0
Joined: Jan 5, 2014 11:10:09 GMT -6
|
Post by dragonsavage28 on Jan 5, 2014 18:50:10 GMT -6
So that means I'll have to use same engine casting from my trike and bore the engine for bigbore with stroker ..
Sent from my HP 7 using proboards
|
|
New Student
Currently Offline
Posts: 6
A+'s: 0
Joined: Jan 5, 2014 11:10:09 GMT -6
|
Post by dragonsavage28 on Jan 5, 2014 14:13:57 GMT -6
2009 icebear pst150-8 viking (ruckus clone) trike..150cc with reverse.no trunk..changed seat to Honda ruckus..unifilter and nodded stock muffler uses either 30mm cvk carb or 28mm oko flatside carb...engine is completely stock. ..  |
|
New Student
Currently Offline
Posts: 6
A+'s: 0
Joined: Jan 5, 2014 11:10:09 GMT -6
|
Post by dragonsavage28 on Jan 5, 2014 12:12:42 GMT -6
I have 2009 icebear pst150-8 viking terike ( ruckus clone )...I've been wondering about the reverse system on it...is there any way that we can get new engine case block and take reverse gear and housing off the old engine and put on new engine case???would this work??? I want to get new engine case that already been bored out for big bore kit and slap on reverse system without modding my framing to make it fit????I found some engine that has reverse build-in but engine and shock bushing measurement is off and require to mod the rear framing I don't want to mod my framing..anyone out there know about this???help please...thanks
Sent from my HP 7 using proboards
|
|
New Student
Currently Offline
Posts: 6
A+'s: 0
Joined: Jan 5, 2014 11:10:09 GMT -6
|
Post by dragonsavage28 on Jan 5, 2014 11:53:44 GMT -6
What is stock roller weight? Stock variator size??115 or 117?? Need those specs for my tuning logs sheet..any info is greatly appreciated...
Sent from my HP 7 using proboards
|
|
New Student
Currently Offline
Posts: 6
A+'s: 0
Joined: Jan 5, 2014 11:10:09 GMT -6
|
Post by dragonsavage28 on Jan 5, 2014 11:49:27 GMT -6
I recently gotten ncy 1500 clutch spring and contra spring and was wondering if it'll be OK to use on my icebear pst150-8 viking...I will be putting 180cc bigbore with stroker using either 30mm cvk carb or 28mm oko flatside carb. Any suggestion???
Sent from my HP 7 using proboards
|
|
