New Student
Currently Offline
Posts: 6 
A+'s: 0
Joined: Jul 13, 2016 9:35:16 GMT -6
|
Post by bush87 on Jul 24, 2016 11:40:46 GMT -6
it has two tanks oil & gas., it had a little oil in it but ill change it to higher grade 2 stroke oil, and the gas tank was empty i only run 93 non ethanol in all my stuff.
Dumb question here? i figured it pre mixed threw the motor with two tanks.
|
|
New Student
Currently Offline
Posts: 6
A+'s: 0
Joined: Jul 13, 2016 9:35:16 GMT -6
|
Post by bush87 on Jul 22, 2016 21:11:41 GMT -6
Got it running, i rechecked the wire with a meter to confirm voltage on wiring and found the kill switch wire also, she runs but smoked real bad maybe from sitting up. Found the vacuum fuel pump bad no biggie there.
Is there an adjustment on the oil intake the motor gets or is it tuned with the carb to lean it a little, the plug was black black and was loaded up, i'll run high test gas and see if it still smokes bad after i get some miles on it.
Thanks for the help every little helps.....
|
|
New Student
Currently Offline
Posts: 6
A+'s: 0
Joined: Jul 13, 2016 9:35:16 GMT -6
|
Post by bush87 on Jul 21, 2016 10:37:35 GMT -6
i think i got the wire figured out, is this a DC-cdi or AC-cdi i need? It had 5 wires on the cdi side after i pulled the tape back.see if this is correct from the drawings I've looked at.
Black/white- Ignition coil
Black- Ground/Thermo element i guess motor temp
Green- Ground/ shows alarm system
Blue/white- Trigger coil
Black/red- Magneto
|
|
New Student
Currently Offline
Posts: 6
A+'s: 0
Joined: Jul 13, 2016 9:35:16 GMT -6
|
Post by bush87 on Jul 20, 2016 16:31:47 GMT -6
Im back going to do as said above, wasn't sure what was there in the first place? Alarm? Going to tear it apart and see what happening in there and were they go.
|
|
New Student
Currently Offline
Posts: 6
A+'s: 0
Joined: Jul 13, 2016 9:35:16 GMT -6
|
Newbie
by: bush87 - Jul 15, 2016 9:06:53 GMT -6
Post by bush87 on Jul 15, 2016 9:06:53 GMT -6
Hey there new to the forum, i buy these things because there cheap, been doing the chinese 4 wheels for a while.Been reading around on here some great info.
|
|
New Student
Currently Offline
Posts: 6
A+'s: 0
Joined: Jul 13, 2016 9:35:16 GMT -6
|
Post by bush87 on Jul 15, 2016 8:14:30 GMT -6
 just picked this up at auction, worked on Chinese 4 wheels never a scooter. its a yamati 2002 2 stroke with a 50cc. Looks like this may be an alarm system wiring and a cdi wiring not sure its in the floor board of the scooter looks as if a mice chewed on it. Thanks for any input, will be working on it when i get back from vacation.  |
|
