New Student
Currently Offline
Posts: 13 
A+'s: 0
Joined: Aug 30, 2015 14:48:45 GMT -6
|
Post by mredman on Sept 13, 2015 10:32:14 GMT -6
OK tried that and no problem there.
|
|
New Student
Currently Offline
Posts: 13
A+'s: 0
Joined: Aug 30, 2015 14:48:45 GMT -6
|
Post by mredman on Sept 12, 2015 10:27:07 GMT -6
OK I'll try it today. I'm about ready to take it to a pro. If I can find one. I hate writing stuff out, I would rather talk to people.
|
|
New Student
Currently Offline
Posts: 13
A+'s: 0
Joined: Aug 30, 2015 14:48:45 GMT -6
|
Post by mredman on Sept 11, 2015 13:35:02 GMT -6
Its like when you sit on it it doesn't want to move. Had the side cover off to look at the clutch when this is going on and it will go 5 to7 feet and fall out. The clutch engages and everything works and then after 7 ft or so it falls flat, clutch disengage and it won't move.
|
|
New Student
Currently Offline
Posts: 13
A+'s: 0
Joined: Aug 30, 2015 14:48:45 GMT -6
|
Post by mredman on Sept 11, 2015 13:30:11 GMT -6
Its doesn't matter. I can let it run on the center stand for 15 min. And get the same results.
|
|
New Student
Currently Offline
Posts: 13
A+'s: 0
Joined: Aug 30, 2015 14:48:45 GMT -6
|
Post by mredman on Sept 11, 2015 8:08:06 GMT -6
Both start and run and idle fine. But the minute you hop on and start to go it starts out fine and then it falls on its face! No power and won't move.
|
|
New Student
Currently Offline
Posts: 13
A+'s: 0
Joined: Aug 30, 2015 14:48:45 GMT -6
|
Post by mredman on Sept 11, 2015 8:05:03 GMT -6
Now I'm stumped. I bought 2 bikes from this lady and both are doing the same thing.
|
|
New Student
Currently Offline
Posts: 13
A+'s: 0
Joined: Aug 30, 2015 14:48:45 GMT -6
|
Post by mredman on Sept 10, 2015 17:09:38 GMT -6
The clutch and varitor are working fine. I'm stumped. On the center stand runs fine and revs up! But the minute you sit down on it and try to take off it falls on its face. The only thing we haven't tried is the kick stand switch. When the kickstand is down it runs like crap. I don't think it should be running at all , but like I said I'm stumped. Help please!
|
|
New Student
Currently Offline
Posts: 13
A+'s: 0
Joined: Aug 30, 2015 14:48:45 GMT -6
|
Post by mredman on Sept 4, 2015 8:24:20 GMT -6
We tried that when we pulled the case off. Still does the same thing. It trys to start out good and then the clutch slips and the motor bogs down. I don't get that either, if the clutch slips in the car the rpms go way up. On this scooter when it starts to slip it gos down. If I let it idle after it bogs down and try to go again it will try and take off for a second and then it will fall on its face.
|
|
New Student
Currently Offline
Posts: 13
A+'s: 0
Joined: Aug 30, 2015 14:48:45 GMT -6
|
Post by mredman on Sept 3, 2015 18:40:27 GMT -6
OK I need help. Like I said before, no power. But looking at it while the cover is off it does look like the clutch is slipping. But we took the clutch apart and it is like brand new! And this bike only has 1800 miles on it. It has been sitting for 10 months.
|
|
New Student
Currently Offline
Posts: 13
A+'s: 0
Joined: Aug 30, 2015 14:48:45 GMT -6
|
Post by mredman on Sept 2, 2015 18:28:05 GMT -6
OK. I'm back with same problem. We checked the roller weights and that's working. But then we notice that the clutch outer would spin at first and then stop. So we put it on the lift and center stand and we can stop the tire from spinning with our hands.took it apart and the outer clutch is in spec and the clutch pads have lots of meat on them. Stumped again! Help please.
|
|
New Student
Currently Offline
Posts: 13
A+'s: 0
Joined: Aug 30, 2015 14:48:45 GMT -6
|
Post by mredman on Aug 31, 2015 16:04:51 GMT -6
No I'll try that.
|
|
New Student
Currently Offline
Posts: 13
A+'s: 0
Joined: Aug 30, 2015 14:48:45 GMT -6
|
Post by mredman on Aug 31, 2015 7:09:51 GMT -6
No motor doesn't rev. It's not acting like a slipping tranny. It's like its trying to pull way to much weight.
|
|
New Student
Currently Offline
Posts: 13
A+'s: 0
Joined: Aug 30, 2015 14:48:45 GMT -6
|
Post by mredman on Aug 30, 2015 14:59:10 GMT -6
Hi ima new to boards and I'm suck on this scooter. I have a 2006 history 125. It starts fine and when on the center stand will rev up and the rear tire goes. But when I get on it to ride it bogs down and has no power. At full throttle it will barely move. I replaced the carb, it had weak spark so replaced the coil,cdi,plug,and stator. After all that it starts fine and runs. The rear wheel gos fast when on stand. Minute I get on it and give it gas it starts to move then bogs down to nothing. Please help I'm stumped and my friend is too.
|
|
