New Student
Currently Offline
Posts: 46
A+'s: 0
Joined: Jan 4, 2013 13:20:22 GMT -6
|
Post by uckel on Nov 21, 2013 16:33:57 GMT -6
You could use a basic 4 pin regulator . Tell me about you headlights ac or dc ? John I'm not opposed to 'patching' in something .. but I prefer to plug and play .. |
|
|
|
Post by tvnacman on Nov 21, 2013 16:47:34 GMT -6
Do you know what wire from the regulator powers your head lights ? I would guess the one not in the plug red/white .
John
|
|
New Student
Currently Offline
Posts: 46
A+'s: 0
Joined: Jan 4, 2013 13:20:22 GMT -6
|
Post by uckel on Nov 21, 2013 16:51:23 GMT -6
I don't .. I will try to find this out ...  the stator wires go into the harness and this comes out at the headlight end ... the fat part breaks down into two sets for each side .. the small set it for a white running lights (brown/green) and the bigger set for the hi/lo dual headlights (green/blue/white) ... |
|
|
|
Post by alleyoop on Nov 21, 2013 17:00:56 GMT -6
On his only three wires go into the plug, the Yellow and Red probably are for his Accessories and the other Red for charging the battery. The two yellows, white and red should have voltage the green is ground.
Alleyoop
|
|
|
|
Post by tvnacman on Nov 21, 2013 17:18:14 GMT -6
150cc or 50cc ?
John
|
|
New Student
Currently Offline
Posts: 46
A+'s: 0
Joined: Jan 4, 2013 13:20:22 GMT -6
|
Post by uckel on Nov 21, 2013 17:24:14 GMT -6
150cc ... apologies if I wasn't clear about that ..
|
|
|
|
Post by tvnacman on Nov 21, 2013 17:45:03 GMT -6
I would go to 11pole stator and 7pin regulator and ac relay .
John
|
|
New Student
Currently Offline
Posts: 46
A+'s: 0
Joined: Jan 4, 2013 13:20:22 GMT -6
|
Post by uckel on Nov 21, 2013 17:56:40 GMT -6
This scooter is my daily transportation .. I have recently replaced the motor at 9k miles (original motor had a terrible knock from day one that i believe was a mis-seated crank bearing that finally gave way) but had to use the stator from the old engine as the one that came with the new motor wasn't compatable ..
I am willing to invest in the right stuff .. but I would need a walkthrough for wiring in a new system.
I will most likely switch over to the 11 pole 7 pin setup after I blow these 2 recently ordered R/R's .. which will likely be in under a year
I am confined to daytime travel atm .. so my fingers are crossed that the parts arrive ontime
|
|
|
|
Post by tvnacman on Nov 29, 2013 15:52:57 GMT -6
looks like its out for delivery .
John
|
|
..BAD TO THE BONE..