Bad Bearing and seal By damin69 (Read 500 times)

[damin69]

Ok I have not been able to get the clutch off yet. But The way it moves and leaking is telling me I have a bad Bearing and Seal at the Output shaft to the Clutch.

This is on the Jonway yy250 244cc honda clone with the Long body.

Where would I go to get this bearing and seal or will I be able to get a replacement at the local autoparts for these bearings and seals?

Thanks,
Todd

[richardthescooter3]

damin69, I know when I replace my front axle bearings there was a number on the bearing so I knew which ones to order, not sure about them

[Barnie]

Damin, if you are very careful removing the seal and bearing, chances are you can get them at your local auto parts dealer if you have a supplier of decent size. All they have to do is measure the inside and outside and thickness with a digital caliper. They most likely will be in a metric size. Also as Richard said they both will or should have the bearing numbers on them. You may have to spend a little time matching them up if the numbers don't match. Barnie

[damin69]

Thanks guys.