New Student
Currently Offline
Posts: 2
A+'s: 0
Joined: Mar 30, 2013 9:46:39 GMT -6
|
Post by flyawaydoug on May 1, 2013 20:36:42 GMT -6
I forgot to tell you what scoot. It's a Roketa MC54B 257cc.  |
|
|
|
Post by cruiser on May 1, 2013 21:07:56 GMT -6
Welcome to the forum, Doug. Most of the install is straightforward, but there may be some confusion in connecting the controller to the headlight circuit. The H4 connector has a high beam, low beam, and ground wire. Make sure you are using the low beam hot wire as the controller wire input and the ground is connected correctly. You could have these reversed. If you have a hi-lo HID kit, then you would also be connecting to the high beam hot wire in the original headlight wire assembly. The functioning of the headlights should be the same as the original setup so you will have to start the engine to run the lights. No additional relay is needed as the controller is the relay.
|
|
