Sophomore
Currently Offline
Posts: 91
A+'s: 0
Joined: Nov 1, 2012 15:45:10 GMT -6
|
Post by 04prixgt04 on Jan 10, 2013 0:01:39 GMT -6
it will run if I started in give it gas in keep it going. But as far as I don't even goes no way. Solo for on its side pretty hard while I was standing up I don't know how but it just happened unfortunately. Anyways I'm sure it's a carburetor problems but I have to go to bed as I need to be at work really really early and I have to have it working. Any ideas right off the bat did you know if I'll be reading this early in the morning thank you
|
|
|
|
Post by alleyoop on Jan 10, 2013 0:07:05 GMT -6
Check and see if the Air Filter Tubeing came off or the carb came loose or the BOOT CAP on the Plug came off the plug a little or a vacuum line came off etc..
Alleyoop
|
|
Sophomore
Currently Offline
Posts: 91
A+'s: 0
Joined: Nov 1, 2012 15:45:10 GMT -6
|
Post by 04prixgt04 on Jan 10, 2013 17:22:46 GMT -6
I checked everything. The only thing I could find was a small hole in the rubber tube from the air filter to the carburetor. And I don't think that's causing the problem. I turn the idle up and miss work for a little while. But then the bike started dying at idle again. I am going to go home and toy with it some more.
|
|
|
|
Post by alleyoop on Jan 10, 2013 18:43:26 GMT -6
Well any extra air it sucks in it will bog on you. So make sure there are no cracks on the intake manifold and or the carb clamps are loose. If you can take a picture of the carb area showing some of the hoses that might help. Also check the Two wires going to the COIL they may have come loose.
To find AIR leaks get a Spray bottle of water and start it up and spray individual areas, by the intake manifold where it conects to the motor around where the clamps are etc also by the air filter area Vacuum lines etc.. When Spraying it the IDLE CHANGES you found a leak.
Alleyoop
|
|
..BAD TO THE BONE..