New Student
Currently Offline
Posts: 2 
A+'s: 0
Joined: Jul 4, 2020 9:34:32 GMT -6
|
Post by mpdano on Jul 4, 2020 14:13:40 GMT -6
Found a post to test the 3 wires. Black is Pos. There are 2 greens coming out of my gauge, one is showing battery voltage and the other climbs as the engine warms up. Looks like my Chinese Temp Gauge is fubar.
|
|
New Student
Currently Offline
Posts: 2
A+'s: 0
Joined: Jul 4, 2020 9:34:32 GMT -6
|
Post by mpdano on Jul 4, 2020 9:40:10 GMT -6
Hello all,
Doing a resto on my 205cc Scoot. I am having issues trying to figure this one out. Cooling system works fine, both hoses get warm and fan turns on when it needs to. Flushed old coolant and put new. I've replaced the temp sensor located near the carburetor, but the temp gauge never moves. When I did replace the sensor, no coolant came out, but when I ran it, coolant came out the sensor hole (water pump functioning).
I've also tightened down the 3 wires at the gauge itself and even loosen/tight movement while watching the gauge to see if it was a bad contact. Nothing.
Are there some more troubleshooting procedures?
Much Thanks, Leo
|
|
