Pulse lightspeed 2 back break light issue. By kersie (Read 245 times)

[kersie]

Hello, I've had my pulse lightspeed for over a year with no problems whatsoever, today I attempted too start the bike with the electric start worked fine with the back break. After I finished work in the evening I tried too start the bike again and engine didn't even turn over, no clicking, nothing.

I then noticed my break light wouldn't light up when the back break was held. But it worked fine with the front. The back break itself still physically works but I can now only use the electric start with the front break held down (pretty awkward) my kick start also works absolutely fine.

I'm guessing maybe my left break switch has gone? I can start the engine fine with the front held and using the electric start.

Any advice would be great.

[JR]

kersie It's either a bad connection with the switch or a bad brake switch itself. You'll need to pull it apart and check the connections and then you can test it with a multimeter to see if it is still good.

JR

[cyborg]

Jr's on it switch or one of the terminals is loose,,,,but my money is on a bad switch