New Student
Currently Offline
Posts: 1 
A+'s: 0
Joined: Nov 22, 2014 18:44:40 GMT -6
|
Post by nakerenski on Nov 22, 2014 18:47:52 GMT -6
im running into an issue with mine. gy6 motor. 150cc lifan lf-150t-6. new magneto/stator, cdi box and coil. still no spark. anyone here know ehere else to look...im at a loss. also, anyone here know the wiring for the regulator. gotta put one on it due to failure at the connector of the old one.
|
|
Sophomore
Currently Offline
Posts: 67
A+'s: 0
Joined: Apr 8, 2012 4:24:33 GMT -6
|
Post by minesweeper on Nov 22, 2014 19:18:27 GMT -6
It is a good idea to start a new thread when you have a new topic and not adding to the old thread. But no biggie, what are the wires coming from your stator? Is it G/Y/W or three yellows? Now, you should also have a blue/something coming out from the stator and running to the CDI. That is your trigger coil. Unhook it from the bullet connector, set your multi to AC for very low voltage, less than 10 volts, put one probe in the stator side connector, ground the other, and turn the engine with the starter and the killswitch to run. What is the voltage?
|
|
|
|
Post by alleyoop on Nov 22, 2014 19:46:18 GMT -6
|
|
..BAD TO THE BONE..