Electrical Sucks! By patches (Read 634 times)

[patches]

I have a SunL 150cc scooter with a remote start.
PROBLEMS:
I am unable to start it with the key (although I can start it with remote start.
Brake lights, blinkers (all), hazards and horn do not work.

DOES WORK:
Remote start, kill switch, running head light, passing lights.

CHECKED:
Starter (scooter did start when kill switch was set to start/crank AND key was in OFF position).
I disconnected alarm and scooter did not start. After scooter is started I am able to disconnect alarm and scooter will still run.
Battery is charged.

CONCERNS:
If its wiring, what wrote would knock out horn, blinkers, brake light and electric start switch.
Ive only found one fuse (15A), if there's another... where and what does it power?

FINALLY:
I feel it was the stupidest thing I did.
Brought it to a guy that said he could fix it.
Well he DID get two(2) blinkers to work; brake lights to work only when the front brake is applied (not back) with incredible hulk strength and it would occasionally start with the remote.
BUT remote start no longer worked, and he hilled the kill switch, it was completely useless.
Since then everything is back to my original problem.

Does anyone have any good trouble shooting insight?

[alleyoop]

The way remotes work is IF you start them with the remote you have to kill it with the remote. Once started with the remote it is expecting the next thing is to be shut off by the remote. The hot is being sent to the remote box and it passes the 12v to the key When the remote is used it cuts off the 12v to the ignition key and it controls the 12v. So in order for it to pass the 12v to the ignition key you have to complete the programmed memory for the remote, which is start and kill with the remote. Also you have to Disarm the Alarm I believe you have to hit the disarm twice.

You can also eliminate the remote and alarm they are Parasites for draining the battery.
Find the box and plug and see if any of the following are present if so you can bypass it.

Find the alarm/remote start module and find the white plug for it. Unplug it from the wiring harness then check the wire colors if you have a Brown/White and a Black/White wire or 2 Black and White wire or a Grey and a Pinkish wires in the harness plug join them together with another wire. .

So the wires your looking for To JUMP are:
1. A Brown /White and a Black/white wire
2. Or 2 Black and White wires
3. Or a Grey and a Pinkish wire


If the alarms have a fuse just remove the fuse and leave it plugged in.
Alleyoop