alarm installation 2008 qlink peg 150cc By jlrod09 (Read 918 times)

[jlrod09]

its been along time now im back

whats up my fellow scooter riders

I have this project currently on hand

I have an alarm system that I want to install on my scooter

I have only gone as far as getting power to the alarm module , and hooking it up to the turn signals ..

what I want to accomplish is being able to ride it with out the key in the ignition here is the diag of the alarm

Attachments:

[jlrod09]

here is the diag of my scoot ...

whats next .....
I want to hook it up so I can remote start it . and ride with out the key

Attachments:

[JR]

Sorry I missed this, let me look it over and I'll get back.

JR

[jlrod09]

thanks JR

[JR]

Ok jirod09 this is how to wire the alarm based upon the diagram you gave me for your scooter:

RED to red positive on battery/key switch
BLACK to ground
ORANGE to Black on key switch
YELLOW to right blinker wire= sky blue
YELLOW to left blinker wire = orange


Now fine the Black/White wire to the CDI from the key switch and cut the wire. Put the PINK wire to the black/white going to key switch and put the GREY to the black/white going to the CDI.

BLUE ties in to the RED/YELLOW on the start button.

Terminate the white wire going to the optional relay. This would be used if the engine was starter by means of positive current going to the starter relay which you don't have.

Sorry I took so long.

JR

[jlrod09]

your the man JR . that's why I only come to scooter professor ;D