Sophomore
Currently Offline
Posts: 66
A+'s: 0
Joined: Oct 29, 2012 12:29:33 GMT -6
|
Post by ridecheap on Dec 3, 2012 18:21:28 GMT -6
I am changing my stator today. I had to take the exhaust manifold off and the rubber gasket is falling apart.
Could you give me a link to a 2007 Roketa MC-54 250b header/ manifold gasket.
I also took off the metal part where you put new oil in. The stator is right behind that. That takes a gasket also.
I need a gasket link for that also.
Looks like my wires were melted together up the stator. This should solve my stator problem.
Just need those two gaskets to order.
|
|
Sophomore
Currently Offline
Posts: 66
A+'s: 0
Joined: Oct 29, 2012 12:29:33 GMT -6
|
Post by ridecheap on Dec 3, 2012 18:39:18 GMT -6
Ok I found a manifold gasket. I measured mine its 38 mm found one on ebay thats metal not rubber.
Now I need a Stator gasket........ Any tips.
|
|
|
Post by alleyoop on Dec 3, 2012 19:54:16 GMT -6
|
|
Sophomore
Currently Offline
Posts: 66
A+'s: 0
Joined: Oct 29, 2012 12:29:33 GMT -6
|
Post by ridecheap on Dec 5, 2012 9:09:19 GMT -6
Call me a bad person but I just re used the old gasket. It was not that bad and I was not going to pay over five bucks for a new one ;D Still waiting on my metal 38mm exhaust gasket. The rubber one now is shot.
|
|
|
Post by fflintstone on Dec 5, 2012 19:21:35 GMT -6
Hi ride cheap,I easily made a gasket fora the exhaust out of wire ,the wire we use to tie chain link fence to the posts and top rail...the tie wire is just the right thickness to fit into the gasket groove..but first you must make a perfect circle out of it...I wrapped a length of wire around a pipe about the same as the same circumference of the exhaust pipe and then cut it to fit..the wire is aluminum and easy to fit in and if there is a small gap,the heat will seal it..my home made gasket is still working after a couple years...I actually documented this on another forum with photos...it is a perfect cheap fix,and lasted longer than the original...if you got any redneck in you,you can do it---lol--good luck, Merry Christmas,fflintstone
|
|
|
Post by alleyoop on Dec 6, 2012 23:57:30 GMT -6
|
|