converting electrical from AC DC xinguye xy150t-7 By jlrod09 (Read 2,682 times)

[jlrod09]

hi yall ,

here is the scoop , i have sen in other forums of one being able to converting the electrical systel on the scooter from AC to a DC fried system

any clues on how to do this

[JR]

There are those who have had some success with this but it's for sure not for a novice, not saying you are one but it does take some time.

thescooterprofessor.proboards.com/index.cgi?action=display&board=elec&thread=1398

But myself I would go this route as many have with good success and this gives lots of power too.

thescooterprofessor.proboards.com/index.cgi?board=elec&action=display&thread=297

But here's another problem you may run into? That engine is not the typical 157QMJ, I don't remember the engine number but I know the valves are different and the variator is 123mm I believe?

Don't know about the stator? Can you give me the engine number?

JR

[JR]

Just found this;

GY6-B 16 Inch Wheel (BN157QMJ)

The Chinese GY6-B engine, number BN157QMJ, is manufactured by BenNeng of Zhejiang Zhongneng Industry Group. This engine is similar in appearance to the standard GY6, but is not. Some parts interchange, but most do not. They are most readily identified by their 16" rear wheel. Some of the most common models include the Lance Phoenix 150cc Scooter, Fly Cadenza, Zhen ZN150T-18, Xingyue ITA 150cc, Motorino Cassini 150cc and the CMS Prodigy 150cc.

[jlrod09]

thanks jr . what exactly do you men by it will give off more power , as an generate a stronger spark ß

[jlrod09]

i would very much like to have this scooter at a full DC , because i have a casoli cdi from my old lance vinage 150 which is a DC fired motor

[jlrod09]

thanks again jr .

[jlrod09]

so what do you think i should do with this motor being a non traditional one .

what options do i have

[tvnacman]

Klee please post a pic of your scooter head on and also the dash.
John

[alleyoop]

You can find some parts for that Motor and CVT here, parts for that motor are not to common.
Alleyoop
.scrappydogscooters.com/GY6-B_16__wheel_BN157QMJ.html" rel="nofollow" target="_blank">.scrappydogscooters.com/GY6-B_16__wheel_BN157QMJ.html

[JR]

By more power I mean more DC amps to use out of the charging system. The 11 coil stator upgrade still incorparates a AC powered CDI though.

JR

[alleyoop]

Yep, and very easy to test if its a DC CDI or not, just check the Read Wire on the CDI and if it reads 12V its a DC CDI.
Alleyoop

[jlrod09]

Thanks guys I can't find the darn cdi . I have loooked under the battery compartment . And under the seat. Nothing at all its no were to be found I hate to have to strip her naked to find it

[tvnacman]

its behind the gas tank , infront of the tail light .
out with the seat bucket , off with the rear luggage rack then remove the right side cover .

if you look passed the gas tank you might be able to see it .

I would still like a head on pic of your scooter .

John

[jlrod09]

thanks john tomorrow i will take a pic of it .

[jlrod09]

i am looking for a performance clutch , if im going to change it i should just go all out. instead of droping a stock one again

May 11, 2012 11:51:11 GMT -6 alleyoop said:

You can find some parts for that Motor and CVT here, parts for that motor are not to common.
Alleyoop
.scrappydogscooters.com/GY6-B_16__wheel_BN157QMJ.html" rel="nofollow" target="_blank">.scrappydogscooters.com/GY6-B_16__wheel_BN157QMJ.html