New Student
Currently Offline
Posts: 12
A+'s: 0
Joined: Mar 28, 2016 12:17:51 GMT -6
|
Post by oldgit1 on May 7, 2017 9:44:19 GMT -6
Could not buy a correct cylinder kit for this ped however picked up a minerelli one ...after running over it with a vernier the only difference is the wall thickness of the flat area the new cylinder being 1mm thicker than the original cylinder my concerns are that this may be for rod clearance ...would anyone know it's purpose please ...everything else measures the same as original ...any help would be wonderful, thanks cliff
|
|
New Student
Currently Offline
Posts: 12
A+'s: 0
Joined: Mar 28, 2016 12:17:51 GMT -6
|
Post by oldgit1 on May 7, 2017 9:45:16 GMT -6
Could not buy a correct cylinder kit for this ped however picked up a minerelli one ...after running over it with a vernier the only difference is the wall thickness of the flat area the new cylinder being 1mm thicker than the original cylinder my concerns are that this may be for rod clearance ...would anyone know it's purpose please ...everything else measures the same as original ...any help would be wonderful, thanks cliff  |
|
|
|
Post by cyborg on May 7, 2017 10:09:06 GMT -6
Got a pic of the original?
|
|
New Student
Currently Offline
Posts: 12
A+'s: 0
Joined: Mar 28, 2016 12:17:51 GMT -6
|
Post by oldgit1 on May 7, 2017 10:51:16 GMT -6
What do you think   |
|
|
|
Post by crwford on May 7, 2017 11:08:05 GMT -6
When I was in my shop I would put on wall in question with Dykem and assembly and hand crank a few times and take apart and see if it rub's it. You most likely have no ideal what Dykem is maybe use magic maker. Just thinking
|
|
|
|
Post by cyborg on May 7, 2017 16:36:36 GMT -6
Drop the new one in the case,,, tie a clean rag around the rod end so it doesn't scratch the bore,, I think it's a go
|
|
