New Student
Currently Offline
Posts: 3 
A+'s: 0
Joined: Nov 15, 2016 8:08:53 GMT -6
|
Post by barryajs on Nov 15, 2016 8:20:16 GMT -6
Hi every one im barry and retired from work and got a malaguti phantom 100cc but can not get it to run , i can start it it up but it stops i have swopped round the fuel lines one way it starts with very high revs then stops the other way it srarts right and ticks over them cuts out and stops i have changed the pump but no diference any ideas
|
|
|
|
Post by cyborg on Nov 16, 2016 8:13:34 GMT -6
How long does it run before it stalls?
|
|
|
|
Post by cyborg on Nov 16, 2016 8:18:17 GMT -6
Get it going again then the minute it dies open the fuel tank cap to see if air rushes into the tank if it does there's a fuel tank venting issue,,,,take a VERY SMALL drill and make a hole in the cap,,,that will cure the venting problem
|
|
New Student
Currently Offline
Posts: 3
A+'s: 0
Joined: Nov 15, 2016 8:08:53 GMT -6
|
Post by barryajs on Nov 17, 2016 4:43:38 GMT -6
Hi ,i have tried the tank cap but still stops ,if i connect the fuel pipes one way it will start but revs up high for about one minute if i then change the pipes it starts and will tick over and seems ok but then stops after about two minutes then will not start again unless i change the pipes again
|
|
|
|
Post by cyborg on Nov 17, 2016 8:14:22 GMT -6
It seems to have a fuel delivery problem and by the sounds of the symptoms it's in the carb ,,,but just for fun pull the vacuum line to the auto petcock where it's attached to the intake manifold and see if it's wet with fuel
|
|
New Student
Currently Offline
Posts: 3
A+'s: 0
Joined: Nov 15, 2016 8:08:53 GMT -6
|
Post by barryajs on Nov 17, 2016 8:26:54 GMT -6
I have tried the pipe it was dry
|
|
|
|
Post by cyborg on Nov 18, 2016 8:04:21 GMT -6
Pull the fuel line from the in side of the pump and then the manifold vac line and draw vacuum on it to see if the fuel flows
|
|
