|
|
Post by richardthescooter3 on Apr 19, 2014 18:51:47 GMT -6
 Installed my new windshield and can't seem to put the center piece on right, get one side and then it seems like its binding up on one side. Any suggestion  |
|
|
|
Post by alleyoop on Apr 19, 2014 19:18:15 GMT -6
I think I know what you did, you put some washer either under the windshield or under the Screw. That makes the plastic cover not fit either the screws are sticking up to much or the whole windshield if you put some kind of washers under it or under the screws.
Alleyoop
|
|
New Student
Currently Offline
Posts: 45
A+'s: 0
Joined: Aug 8, 2013 22:37:56 GMT -6
|
Post by johnny3d on Apr 19, 2014 20:07:01 GMT -6
Is it a stock windshield? I ask because I put a Cee Baileys windshield on my YY250T and since it was thicker than the original, I had to make some modifications to the front cowl so that it would fit right. Even then I had to add an extra screw down under the very front to keep it from popping out of place.
|
|
|
|
Post by richardthescooter3 on Apr 20, 2014 4:43:06 GMT -6
Your right Alleyoop, removed some of the washers and the re-cut where the cover goes in. (Got it on, looking good). Thanks all. now working the CVT area.
|
|
..BAD TO THE BONE..
