|
|
Post by richardthescooter3 on Oct 13, 2013 6:34:59 GMT -6
Hey guys, been have trouble with my RPM"S too high at stops, Alleyoop suggested to adjust my idle, but as I turn idle down while on center stand, the idle stays the same 2,000 to 2,200 RPM'S.
|
|
|
|
Post by alleyoop on Oct 13, 2013 8:30:31 GMT -6
Check your throttle cable it should have about 1/4 inch of play BEFORE it actually pulls on the cable to open the BUTTERFLY. It is either to tight or binding and not closing all the way. Did you happen to take the carb off or messed around with the carb?
Alleyoop
|
|
|
|
Post by richardthescooter3 on Oct 13, 2013 15:10:38 GMT -6
Alleyoop, I'll check my cable. No I didn't have carb off or messed with it.
|
|
|
|
Post by richardthescooter3 on Oct 13, 2013 15:34:25 GMT -6
Alleyoop, that's what it is. The throttle cable has no play, How do I adjust it? Does it get adjusted at carb where its bolted on?
|
|
|
|
Post by richardthescooter3 on Oct 13, 2013 19:36:07 GMT -6
Well got to my carb and loosen the nuts holding my throttle cable on, adjusted the nuts so there would be more slack towards front of carb where the cable goes on, started the scoot and it seems to be working, I was able to adjust my idle so my back wheel isn't going around as it seats on center stand. (thanks Alleyoop) Will test drive soon.
|
|
|
|
Post by alleyoop on Oct 13, 2013 19:57:21 GMT -6
FANTASTIC!! yea you have some adjustment by the throttle grip as well, but either way by the carb or by the throttle grip.
That is great easy fix GOOD JOB.
Alleyoop
|
|
|
|
Post by richardthescooter3 on Oct 14, 2013 7:21:47 GMT -6
Alleyoop, Test drove my scooter this morning and idle is good around 1800  I could feel the clutch releasing at stop  still rough starting out  might need roller weights, never changed them since I got scoot. |
|
..BAD TO THE BONE..