|
|
Post by richardthescooter3 on Jun 1, 2013 15:34:25 GMT -6
I finally got the hose on my air box to fit better  found the problem  when I had the air box loose and was pushing it on the carb, I notice the air box hitting my starter and not allowing me to push it on as far as I wanted  had to pull on rubber hose and hold it there to tighten it  Attachments:
|
|
|
|
Post by justbuggin2 on Jun 1, 2013 21:43:34 GMT -6
great that you got it  |
|
Sophomore
Currently Offline
Ride Safe Everyone
Posts: 76
A+'s: 0
Joined: May 13, 2013 17:31:51 GMT -6
|
Post by Barnie on Jun 5, 2013 15:44:16 GMT -6
Is your air box hose staying on now ok?? Barnie |
|
|
|
Post by richardthescooter3 on Jun 5, 2013 16:56:03 GMT -6
The air box hose is staying on, but the problem I'm having now is the worm screw clamp keeps working loose and at wot my scoot starts choking (yep clamp loose again). I think about buying a hard rubber hose to go on carb and then slide hose into the hose on my air box and clamp both.
|
|
|
|
Post by alleyoop on Jun 5, 2013 18:23:05 GMT -6
Get a lock washer and put it behind the head screw, the vibration is loosing it.
Alleyoop
|
|
|
|
Post by richardthescooter3 on Jun 6, 2013 7:39:55 GMT -6
Last night check out my worm screw found out I had it striped as I took it off it fall apart replaced it with a new clamp, we will see how it goes today (Thanks Alleyoop, I'll try that) |
|
|
|
Post by richardthescooter3 on Jun 7, 2013 8:44:15 GMT -6
If I wasn't so dumb, I be stupid After changing the clamp and tighten good, ran good Wednesday, took scoot to work Thursday and on the way home started to choke at 60 to 65mph got home recheck clamp (it was loose again) When I replace the clamp i turned it around facing out ;D (easier to get to) so as I look at the clamp (I FINALLY CAME TO ME)  the voice said, bend the tab down after you tighten it that way it can't work itself loose. So I did and ran it today at high speed and had no problems  |
|
..BAD TO THE BONE..