My Build So far (PICS) By scooterelements (Read 1,396 times)

[scooterelements]

Here are a few pics of my build. Just installed the NCY Valves and Springs with the Titanium Valve Retainers on my 61mm NCY Head. We ran into a small problem when installing the cylinder spacer it did not fit by a very small amount so we are going to just grind down a little big to get it to fit. So far so good Got the 6mm Stroke crankshaft in there. High Performance Starting Clutch all installed. Waiting on a Taida High Torque Starter to arrive next week then we will focus on the CVT Area

All these parts except for the retainers are available on my site. Also we can install the valves and springs for you at no additional charge. Send us your valve head or buy one of ours and we will install them and send it back to you Just send us a message

[jct842]

I like the head. If and when my 150 gets worn that is what I think I would like on mine. As far as I can see on improvements the head and some cooling is what I would want most. john