New Student
Currently Offline
Posts: 44
A+'s: 0
Joined: Sept 10, 2011 15:23:42 GMT -6
|
Post by kczukiman on Jul 16, 2012 20:27:53 GMT -6
Hey all,
Has anyone experianced a rough shimmy or vibration on take off ?I have about 890 miles on my new Jonway yy250 with the honda clone.
|
|
|
|
Post by alleyoop on Jul 16, 2012 20:55:18 GMT -6
Check your clutch it is probably slipping at those low RPMS and will make the scoot shudder until enough centrifugal force with a little higher rpms are applied then the Pads grab the bell good.
Alleyoop
|
|
New Student
Currently Offline
Posts: 44
A+'s: 0
Joined: Sept 10, 2011 15:23:42 GMT -6
|
Post by kczukiman on Jul 16, 2012 21:00:01 GMT -6
Think it may be glazed? I will check it tomorrow. It will be a good time to change the gear oil too.
Thanks !
|
|
New Student
Currently Offline
Posts: 44
A+'s: 0
Joined: Sept 10, 2011 15:23:42 GMT -6
|
Post by kczukiman on Jul 19, 2012 17:48:52 GMT -6
Due the heat I haven't been opening the garage door except to put the bike in and out from work. I did read a thread on putting the bike on the center stand and holding the rear brake while reving to the rmp that the sputter is happening for 30 seconds. It did work. Don't know for how long.
|
|
..BAD TO THE BONE..