|
|
Post by richardthescooter3 on Sept 5, 2012 13:10:37 GMT -6
If you have this carb, this is how it should look before putting lid on. Attachments:
|
|
|
|
15 Grand
by: richardthescooter3 - Sept 5, 2012 8:46:55 GMT -6
Post by richardthescooter3 on Sept 5, 2012 8:46:55 GMT -6
Congrats tankrider  My scoot almost 12,000 miles. |
|
|
|
Post by richardthescooter3 on Sept 5, 2012 8:43:12 GMT -6
|
|
|
|
Post by richardthescooter3 on Sept 5, 2012 7:33:18 GMT -6
Received my new brake pads for rear wheel yesterday  installed brakes last night I'm going to be more careful not to over used the back brakes from now on, marked in notebook how many miles to keep track  |
|
|
|
Post by richardthescooter3 on Sept 5, 2012 7:24:05 GMT -6
JR, Scooter good to go now |
|
|
|
Post by richardthescooter3 on Sept 4, 2012 9:14:07 GMT -6
JR, When I first started scoot it idles about 2200 RPM'S then after about a few minutes it slowly goes down to around 1200, so as it running I adjusted the idle to 1800, So I did get it back up there, we will see have that works |
|
|
|
Post by richardthescooter3 on Sept 4, 2012 8:16:46 GMT -6
It seems to do this to me by times, but when I do move the idle up, it seems to take time for it to move up, I don't get immediate responds.
|
|
|
|
Post by richardthescooter3 on Sept 4, 2012 7:41:58 GMT -6
reinhardt, I have a scoot just like yours. Is yours the linhai/yamaha clone or do you have the honda clone?
|
|
|
|
Post by richardthescooter3 on Sept 3, 2012 18:35:31 GMT -6
Yes reinhardt, your startor and R/R keep your battery charged up.
|
|
|
|
Post by richardthescooter3 on Sept 3, 2012 18:23:32 GMT -6
Just recently my scooter take a little longer to start,  when I first crank it up, it starts for a second and then crank again starts again for a second, it may take 4 or 5 of these starts to finally stay started, I did notice the idle was low about 1500, what could it be  once its warmed up it will start right up, I did check the enricher is working. Attachments:
|
|
|
|
Post by richardthescooter3 on Sept 2, 2012 21:46:10 GMT -6
Hope You get scoot work right |
|
|
|
Post by richardthescooter3 on Sept 2, 2012 6:11:43 GMT -6
Thanks cruiser |
|
|
|
Post by richardthescooter3 on Aug 31, 2012 18:22:21 GMT -6
Congrats Bob, I knew you would find away to get the job done |
|
|
|
Post by richardthescooter3 on Aug 31, 2012 18:18:35 GMT -6
Here is back brakes Attachments:
|
|
|
|
Post by richardthescooter3 on Aug 31, 2012 18:11:54 GMT -6
Hi Bob, front brake are good I'm looking now to buy a set of pads for the rear. |
|
