New Student
Currently Offline
Posts: 1 
A+'s: 0
Joined: Feb 14, 2016 20:47:58 GMT -6
|
Post by jeffker on Feb 14, 2016 21:22:17 GMT -6
Can I put a fuel injection unit from a Honda sh150i onto a gy6 engine?
|
|
|
|
Post by JR on Feb 15, 2016 21:04:30 GMT -6
 jeffker Good question? I would think anything is possible but one thing I know for sure is you would have to upgrade the stator on the typical GY-6 because fuel injection requires a good amount of power. JR
|
|
|
|
Post by cyborg on Feb 18, 2016 8:03:47 GMT -6
Yes I don't see why not,,,but Jr brings up a very important point,,,the stock gy6 stator is weak at best,,,if you upgrade that the conversion should be great,,,you'll get rid of two of the biggest weaknesses in these scoots
|
|
|
|
Post by tvnacman on Feb 26, 2016 17:46:16 GMT -6
Yes I don't see why not,,,but Jr brings up a very important point,,,the stock gy6 stator is weak at best,,,if you upgrade that the conversion should be great,,,you'll get rid of two of the biggest weaknesses in these scoots What the carb and what is the second? John |
|
|
|
Post by cyborg on Feb 26, 2016 21:47:33 GMT -6
The stock stator on most Chinese scoots is weak,,,the Internet and forums are filled ways to work with the original and cut down consumption with LEDs or change / upgrade to more powerful units,,,it's not just Chinese products either I had a Suzuki dr650 which are notorious for their weak output,,,and the same arrangements are done,,,run with the stocker and go led lights ( which I did and put a headlite cutoff switch so no lites till I got it fired) or send out the original stator to be rewound or replace with a high output unit,,,and carburetion,,,a real mikuni round or better yet flat slide carb wakes these machines up,,,I even put a VM series round slide mikuni on my first vespa,,,best thing that ever happened to that thing,,,
|
|
