scooter bent? need help By nledesma85 (Read 718 times)

[nledesma85]

hello. my scooter today is like bent at an angle. I can bend it back to its normal position, but if I ride it, then it bend more. the rear wheel and engine bend together. it's a znen 150t-e

Attachments:

[nledesma85]

I just noticed that the previous picture i took sucked. I hope this one is better. What could cause the entire rear half of the scooter to bend like this?

Attachments:

[richardthescooter3]

Looks like the bearing in swing arm is shot. show side pic, muffler side.

[nledesma85]

I finally got it towed home and I took the seat off this is what I found. A crack in the frame? I'm not sure what the part name is but I can see the crack. The first picture shows where the damage is. The second one is zoomed in. Thank you for any help or advice. My fiance is very attached to her.

Attachments:

[nledesma85]

zoomed in picture

Attachments:

[nledesma85]

ok. So after even further inspection it is not the frame! it is the engine hang / mount. I found one at

.racingplanetusa.com/engine-hanger-150cc-p-22495-1.html?cPath=28091_29967_29969" rel="nofollow" target="_blank">.racingplanetusa.com/engine-hanger-150cc-p-22495-1.html?cPath=28091_29967_29969

Pretty cheap. but I do not know if I am capable or have the right tools to do this work. What does anyone else think?

[richardthescooter3]

Look and see how much you have to take off scoot to get to it, then look and see what comes off to fix, take pic as you do this job, once your into it, the part itself don't look to hard to put on.

[jlrod09]

thats actually the engine support bracket . you have to remove the engine to get that off. i had a znen i did a big bore on . had to dismantle the rear to get engine off

[nledesma85]

Ok, well I ordered the part and took the body panels off. After really getting in there, I am fairly confident that I can do it. Now I just have to wait for it to get here.......

[nledesma85]

AAhhh! So two weeks later and patiently waiting on shipping, the part finally arrived. And... its about a half inch too long. Feels bad man, Im trying to return it now and roll the dice on another product that will hopefully fit in the frame.

[nledesma85]

Does anyone know where to find this part, but not the 14" version, i need one about 34cm long?