|
|
Post by damin69 on Jul 14, 2014 10:49:41 GMT -6
So I am just about due to adjust the Valves on my Linhai and there is very little room for getting tools in there so I had been looking around and I found these Valve Wrenches I was wondering if anyone else uses them and how they like them. I ordered a set and should be getting them in the next week. |
|
|
|
Post by alleyoop on Jul 14, 2014 13:38:41 GMT -6
I have a set and use them Makes the job easier that plus the feeler gauges is all you need. Set the gap Hold the Stud with the top wheel and tighten piece of cake.
Alleyoop
|
|
|
|
Post by bobf on Jul 16, 2014 16:03:12 GMT -6
Are these wrenches good for both the horizontal and vertical engines? I have the vertical 244cc engine, not many miles yet but surely going to need to do a tune up one of these days. Right now in southern Arizona it is doing a lot of sitting in the garage.. Do I need a set or just one?
.
|
|
|
|
Post by alleyoop on Jul 16, 2014 18:06:48 GMT -6
No, on yours you do not need such a tool, because you have the HELIX 244cc motor it has the valve adjustments on the outside on the valve cover. Here is how you adjust those piece of cake really. I wish they would make them all this way  Alleyoop |
|
|
|
Post by bobf on Jul 18, 2014 7:02:39 GMT -6
Thanks Alleyoop. I guess I can save my pocket money for something different.
If it cools down a bit my scoot will come out of the garage more often.
.
|
|
..BAD TO THE BONE..
